Dodge Sprinter 2006 Manual page 1835

VA
I N PU T CLU T CH K 2
DISASSEMBL Y
1 - NEEDLE ROLLER BEARING
2 - K1 INNER DISC CARRIER WITH INTEGRATED FRONT GEAR
SET
3 - THRUST BEARING
4 - TORLON SEAL RINGS
5 - INPUT SHAFT AND K2 CLUTCH
6 - PISTON OUTER SEAL RING - O-RING
7 - PISTON INNER SEAL RING
8 - THRUST WASHER
9 - PISTON
10 - DISC SPRING
(1) Rem ove sn a p-r in g (19) fr om t h e K1 in n er m u l-
t iple-disc ca r r ier wit h in t egr a t ed fr on t gea r set (2)
a n d t a ke off h ollow gea r (18).
(2) Rem ove in pu t sh a ft wit h clu t ch K2 (5) (F ig.
88).
(3) Rem ove n eedle t h r u st bea r in g (3).
(4) Rem ove sn a p-r in g (17) (F ig. 88) fr om K2 ou t er
m u lt iple-disc ca r r ier.
(5) Ta ke ou t m u lt iple-disc pa ck (16). Not e wh ich
clu t ch disc is r em oved ju st pr ior t o t h e disc spr in g
(14) for r e-a ssem bly. If t h e clu t ch discs a r e r e-u sed,
t h is disc m u st be r et u r n ed t o it s or igin a l posit ion on
t op of t h e disc spr in g.
(6) Ta ke ou t disc spr in g (14) (F ig. 88).
AUTOMA TIC TRANSMISSION NAG1 - SERVICE INFORMA TION 21 - 97
Fig. 88 Input Clutch K2 Components
11 - SPRING RETAINER SEALING - O-RING
12 - SPRING RETAINER
13 - SNAP-RING
14 - DISC SPRING
15 - EXTERNALLY TOOTHED PLATE - 1.8 MM (0.071 IN.)
16 - MULTIPLE DISC PACK
17 - SNAP-RING
18 - HOLLOW GEAR
19 - SNAP-RING