Dodge Sprinter 2006 Manual page 1982

23 - 44 DOORS - SLIDING
(14) In st a ll t h e door. (Refer t o 23 - BODY/DOORS
- SLIDING/SLIDING DOOR - INSTALLATION)
INSTALLA TION
(1) In st a ll t h e door by in ser t in g t h e cen t er a n d
u pper r oller s in t o t h e t r a cks a n d slidin g t h e door for-
wa r d t o t h e fr on t of ea ch t r a ck.
(2) Con n ect t h e lower r oller a r m a n d in st a ll t h e
scr ews.
(3) Tigh t en t h e scr ews t o 25 N·m (18 ft . lbs.).
(4) In st a ll door st op a n d scr ews.
(5) Tigh t en t h e scr ews t o 10 N·m (89 in . lbs.).
(6) In st a ll t h e cen t er t r a ck en d piece a n d in st a ll
t h e scr ew.
(7) Tigh t en t h e scr ew t o 10 N·m (89 in . lbs.).
(8) Ch eck a n d a dju st door if n ecessa r y. (Refer t o 23
- BODY/DOORS - SLIDING/SLIDING DOOR -
ADJ USTME NTS)
(9) Con n ect ba t t er y n ega t ive ca ble.
ADJ U ST M EN T S
ADJUSTMENT
NOTE: Door adjustment measurements should be
taken from stationary or welded body panels like
the roof, rocker or quarter panels.
A suitable body sealant should be used when
removing or moving the hinges.
(1) Rem ove bolt s a n d r em ove st r iker. (F ig. 18)
Fig. 18 LATCH STRIKER
1 - STRIKER
2 - BOLTS
(2) Ch eck ga ps a n d r idge pa t t er n on door a ll t h e
wa y a r ou n d. (Refer t o 23 - BODY/BODY STRUC-
TURE /GAP AND F LUSH - SP E CIF ICATIONS)
NOTE: It must be possible to move the guide wedge
during the entire adjusting procedure. In order to
close the door during adjustment move guide
wedge if necessary.
(3) Loosen gu ide wedge scr ews.
Gaps and Ridge Adjustment
(1) Loosen scr ew a n d a dju st r ea r r idge pa t t er n by
lift in g a n d lower in g slidin g door a t cen t er r oller a r m .
(F ig. 19)
Fig. 19 ADJUST CENTER ROLLER ARM
1 - BOLT
2 - CENTER ROLLER ARM
(2) Tigh t en bolt t o 45 N·m (33 ft . lbs.).
(3) Loosen u pper r oller a r m scr ews. (F ig. 20)
(4) Loosen lower r oller a r m scr ews.
(5) Adju st fr on t r idge pa t t er n by r a isin g or lower-
in g door.
Fig. 20 UP/DOWN ADJUST
1 - SCREWS (2) UPPER ROLLER ARM
2 - SCREWS (2) LOWER ROLLER ARM
(6) Tigh t en u pper a n d lower r oller a r m bolt s t o 25
N·m (18 ft . lbs.).
VA