Dodge Sprinter 2006 Manual page 2077

VA
AIR FILTER
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 45
AIR OUTLETS
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 46
BLOWER MOTOR
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 47
DEFROSTER DUCTS
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 47
AI R FI LT ER
REMOVAL
(1) Rem ove t h e in su la t ion bla n ket fr om t h e ven t i-
la t ion h ou sin g in t h e en gin e com pa r t m en t (F ig. 1).
(2) Open t h e lockin g clips a t t h e fr on t a n d r ea r of
t h e ven t ila t ion h ou sin g.
(3) Slide t h e ven t ila t ion h ou sin g cover in t h e dir ec-
t ion of t h e a r r ow sh own .
(4) Rem ove t h e a ir filt er.
Fig. 1 Air Filter Element
1 - VENTILATION HOUSING INSULATION BLANKET
2 - LOCKING CLIP (2)
3 - AIR FILTER
INSTALLA TION
(1) In st a ll t h e a ir filt er in t o t h e ven t ila t ion h ou s-
in g.
DI ST RI BU T I ON - FRON T
TABLE OF CONTENTS
page
DISTRIBUTION - FRONT 24 - 45
FLOOR DISTRIBUTION DUCTS
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 48
HVAC HOUSING
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
DISASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . 49
ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 50
INSTRUMENT PANEL DUCTS
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . 51
(2) In st a ll t h e ven t ila t ion h ou sin g cover
(3) Close t h e lockin g clips a t t h e fr on t a n d r ea r of
t h e ven t ila t ion h ou sin g.
NOTE: The locking tabs should retain the ventila-
tion housing cover securely.
(4) In st a ll t h e in su la t ion bla n ket on t o t h e ven t ila -
t ion h ou sin g.
AI R OU T LET S
REMOVAL
WARNING: To avoid personal injury or death, on
vehicles equipped with airbags, disable the supple-
mental restraint system before attempting any
steering wheel, steering column, airbag, seat belt
tensioner, impact sensor, or instrument panel com-
ponent diagnosis or service. Disconnect and isolate
the battery negative (ground) cable, then wait two
minutes for the system capacitor to discharge
before performing further diagnosis or service. This
is the only sure way to disable the supplemental
restraint system. Failure to take the proper precau-
tions could result in accidental airbag deployment.
(1) Discon n ect a n d isola t e t h e ba t t er y n ega t ive
ca ble.
(2) If ser vicin g t h e dr iver side a ir ou t let s, r em ove
t h e in st r u m en t clu st er bezel (Refer t o 23 - BODY/IN-
STRUME NT PANE L/CLUSTE R
RE MOVAL).
(3) If ser vicin g t h e pa ssen ger side a ir ou t let s,
r em ove t h e pa ssen ger side a ir ba g (Refer t o 8 - E LE C-
TRICAL/RE STRAINTS/PASSE NGE R
RE MOVAL).
page
BE ZE L -
AIRBAG -