Dodge Sprinter 2006 Manual page 1623

VA
Fig. 45 Compression Ring Installation
1 - COMPRESSION RING
2 - RING EXPANDER RECOMMENDED
Ring Gap Orientation
• P osit ion t h e ga ps on t h e pist on a s sh own (F ig.
46).
• Oil spa cer - Ga p on cen t er lin e of pist on skir t .
• Oil r a ils - ga p 180° a pa r t on cen t er lin e of pist on
pin bor e.
• No. 2 Com pr ession r in g - Ga p 120° fr om t op oil
r a il ga p.
• No. 1 Com pr ession r in g - Ga p 120° fr om No. 2
com pr ession r in g ga p.
Fig. 46 Ring Gap Orientation
1 - TOP COMPRESSION RING
2 - BOTTOM COMPRESSION RING
3 - TOP OIL CONTROL RAIL
4 - OIL RAIL SPACER
5 - BOTTOM OIL CONTROL RAIL
6 - IMAGINARY LINE PARALLEL TO PISTON PIN
7 - IMAGINARY LINE THROUGH CENTER OF PISTON SKIRT
V I BRAT I ON DAM PER
REMOVAL
NOTE: If vehicle is equipped with the additional air
conditioner compressor, you must first remove the
coolant module and additional A/C belt then use
damper puller # 9544.
(1) Discon n ect n ega t ive ba t t er y ca ble.
(2) Rem ove a ccessor y dr ive belt (Refer t o 7 -
COOLING/ACCE SSORY DRIVE /DRIVE
RE MOVAL).
(3) In st a ll r et a in in g lock for cr a n ksh a ft /r in g gea r
(F ig. 47).
(4) Rem ove cr a n ksh a ft cen t er bolt a n d wa sh er
(F ig. 47).
NOTE: If hub of belt pulley/vibration damper is
tight, use puller # 8940 to remove. DO NOT tilt
puller when in use. Grooves of the puller must
mesh fully into the slots of the belt pulley.
ENGINE 9 - 53
BE LTS -