Dodge Sprinter 2006 Manual page 1996

23 - 58 INSTRUMENT PANEL
Fig. 4 CUP HOLDER
1 - SCREWS
2 - CUPHOLDER
(3) Rem ove ven t h ose (1). (F ig. 5)
(4) Un scr ew bolt s (2) a n d r em ove cu p h older bot -
t om sect ion (3) fr om ca b floor.
Fig. 5 CUP HOLDER BOTTOM
1 - VENT HOSE
2 - BOLTS (4)
3 - BOTTOM SECTION
INSTALLA TION
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, DISABLE THE AIRBAG SYSTEM BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING
COLUMN, SEAT BELT TENSIONER, OR INSTRU-
MENT PANEL COMPONENT DIAGNOSIS OR SER-
VICE. DISCONNECT AND ISOLATE THE BATTERY
NEGATIVE (GROUND) CABLE, THEN WAIT TWO
MINUTES FOR THE AIRBAG SYSTEM CAPACITOR
TO DISCHARGE BEFORE PERFORMING FURTHER
DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
(1) In st a ll bot t om sect ion a n d in st a ll t h e bolt s.
(2) In st a ll ven t h ose.
(3) In st a ll t op sect ion a n d in st a ll t h e scr ews.
(4) In st a ll r u bber m a t s.
GLOV E BOX
REMOVAL
(1) Open glove box a n d r em ove t h e scr ews. (F ig. 6)
(2) Rem ove glove box a n d discon n ect elect r ica l con -
n ect or.
Fig. 6 GLOVE BOX
1 - SCREWS (3)
2 - GLOVE BOX DOOR
INSTALLA TION
(1) Con n ect elect r ica l con n ect or a n d in st a ll glove
box.
(2) In st a ll t h r ee scr ews.
VA