Dodge Sprinter 2006 Manual page 1841

VA
ASSEMBL Y
1 - SNAP-RING
2 - MULTIPLE DISC PACK
3 - DISC SPRING
4 - SNAP-RING
5 - SPRING PLATE
(1) In st a ll pist on (6) (F ig. 95) in t h e ou t er m u lt i-
ple-disc ca r r ier (8). Ch eck sea lin g r in g (7), r epla ce if
n ecessa r y. Th e r ou n ded off edges of t h e sea lin g r in g
m u st poin t ou t wa r ds.
(2) In ser t disc spr in g (5). In ser t disc spr in g wit h
t h e cu r va t u r e t owa r ds t h e pist on .
(3) Mou n t t h e Mu lt i-u se Spr in g Com pr essor 8900
(9) on t h e spr in g pla t e a n d cla m p u n t il t h e sn a p-r in g
gr oove is exposed.
(4) In ser t sn a p-r in g (4). Th e colla r of t h e sn a p-r in g
m u st poin t t owa r ds t h e m u lt iple-disc pa ck.
CAUTION: When working with double sided friction
discs, an externally lugged steel plate is installed
first, followed by a friction disc, and continuing on
until all the required discs are installed. When work-
ing with single sided friction discs, an externally
lugged disc is installed first, followed by an inter-
nally lugged disc, and continuing on until all the
required discs are installed. All single sided discs
are installed with the friction side up.
NOTE: Pay attention to the sequence of discs. If the
original clutch discs are reused, be sure to return
AUTOMA TIC TRANSMISSION NAG1 - SERVICE INFORMA TION 21 - 103
Fig. 95 Input Clutch K3 Components
6 - PISTON
7 - SEALING RING
8 - OUTER DISC CARRIER
9 - MULTI-USE SPRING COMPRESSOR 8900
the disc identified on disassembly as belonging on
top of the spring plate (3) to its original location.
NOTE: Place new friction multiple-discs in ATF fluid
for one hour before installing.
(5) In st a ll disk spr in g (3) a n d m u lt iple-disc pa ck
(2) in ou t er m u lt iple-disc ca r r ier (8).
(6) In ser t sn a p-r in g (1).