Dodge Sprinter 2006 Manual page 1791

VA
NOTE: During the measurement the snap ring (7)
(Fig. 49) must contact the upper bearing surface of
the groove in the outer multiple-disc carrier (8).
NOTE: Pay attention to sequence of discs. If the
original clutch discs are reused, be sure to return
the disc identified on disassembly as belonging on
top of the spring washer (4) to its original location.
Place new friction multiple-discs in ATF fluid for
one hour before installing.
(4) In ser t a n d m ea su r e spr in g wa sh er (4) (F ig. 49)
a n d m u lt iple-disc pa ck B3 (2, 6).
(a ) P u t m u lt iple-discs for m u lt iple-disc h oldin g
clu t ch B3 t oget h er in t h e sequ en ce sh own in t h e
illu st r a t ion a n d in ser t in dividu a lly.
(b)
CAUTION: Apply only light pressure (less than 10 N
(3 lbs.) of force) to the clutch pack when measuring
the clutch clearance with the feeler gauge. Applying
excessive force to the clutch will give an incorrect
reading and lead to a transmission failure.Using a
feeler gauge, determine the play "L" at three points
between the snap ring (7) and outer multiple-disc
(1). B3 clutch clearance should be 1.0-1.4 mm
(0.039-0.055 in.). Adjust the clearance as necessary.
(c) Adju st wit h sn a p-r in g (7), if n ecessa r y. Sn a p-
r in gs a r e a va ila ble in t h ickn esses of 3.2 m m (0.126
in .), 3.5 m m (0.138 in .), 3.8 m m (0.150 in .), 4.1 m m
(0.162 in .), 4.4 m m (0.173 in .), a n d 4.7 m m (0.185
in .).
Fig. 50 Check K1 Feed Hole
1 - K1 CLUTCH FEED HOLE
(5) Ch eck t h a t t h e K1 clu t ch feed h ole (1) (F ig. 50)
in t h e in n er h u b of clu t ch B1 is fr ee befor e in st a llin g
clu t ch B1.
AUTOMA TIC TRANSMISSION NAG1 - SERVICE INFORMA TION 21 - 53