Crankshaft Oil Seal - Front - Dodge Sprinter 2006 Manual

9 - 42 ENGINE
1 - FLYWHEEL
2 - FLYWHEEL BOLTS
3 - SPECIAL TOOL 8944
4 - REAR CRANKSHAFT OIL SEAL
5 - REAR CRANKSHAFT SEAL ADAPTER
6 - CRANKSHAFT
7 - ALIGNMENT DOWELS
8 - REAR CRANKSHAFT SEAL ADAPTER RETAINING BOLT
9 - OIL PAN TO REAR CRANKSHAFT SEAL ADAPTER RETAINING BOLT
INSTALLA TION
NOTE: Thoroughly clean all mating surfaces with
the appropriate solvents to assure that no grease or
oil is present during reassembly.
NOTE: Carefully position the rear main seal/adaptor
evenly onto the assembly sleeve. The rear main oil
seal lip MUST NOT roll over the edge of the tool.
(1) P osit ion t h e r ea r m a in oil sea l/a da pt or wit h
a ssem bly sleeve on t o t h e cr a n ksh a ft so t h a t t h e
dowel sleeves fit in t o t h e gu ide h oles (F ig. 33). Ca r e
m u st be t a ken so t h a t t h e oil pa n ga sket is n ot da m -
a ged.
(2) In st a ll t h e r ea r m a in sea l/a da pt or t o cr a n kca se
bolt s a n d t igh t en t o 9·Nm (80 lbs.in ) (F ig. 33).
(3) Tigh t en t h e M6 oil pa n bolt s t o 9N·m (80 lbs
in ) a n d t h e M8 bolt s t o 20 N·m (15 lbs ft ).
(4) In st a ll t h e fly wh eel a n d t igh t en bolt s in t wo
st a ges (F ig. 33). 45N·m (33 lbs. ft .) t h en 90°.
Fig. 33 REAR MAIN SEAL/ADAPTER
25N·m (18 lbs ft ).
t o t h e pr oper level. Refer t o own er s m a n u a l for spec-
ifica t ion s.
WARNING: USE EXTREME CAUTION WHEN THE
ENGINE IS OPERATING. DO NOT PUT YOUR
HANDS NEAR THE PULLEYS, BELTS OR FAN. DO
NOT WEAR LOOSE CLOTHES.
CRAN K SH AFT OI L SEAL -
FRON T
REMOVAL
(5) In st a ll t h e oil pa n dr a in plu g a n d t igh t en t o
(6) Lower t h e veh icle.
(7) F ill t h e cr a n kca se wit h t h e cor r ect en gin e oil,
(8) Con n ect t h e n ega t ive ba t t er y ca ble.
(9) St a r t t h e en gin e a n d in spect for lea ks.
(1) Discon n ect t h e n ega t ive ba t t er y ca ble.
(2) Rem ove t h e a ccessor y dr ive belt .
VA