Passenger Side - Dodge Sprinter 2006 Manual

VA
RADI AT OR CROSSM EM BER
REMOVAL
(1) Rem ove gr ille. (Refer t o 23 - BODY/E XTE RI-
OR/GRILLE - RE MOVAL)
(2) Rem ove h ea dla m ps. (Refer t o 8 - E LE CTRI-
CAL/LAMP S/LIGH TING
LAMP UNIT - RE MOVAL)
(3) Rem ove h ea t sh ield. (F ig. 2)
(4) Rem ove r et a in in g cla m ps a n d r u bber m ou n t s.
(5) Rem ove bolt s.
(6) Rem ove cr ossm em ber
ca ble.
Fig. 2 RADIATOR CROSSMEMBER
1 - HEAT SHIELD
2 - HOOD CABLE
3 - CROSSMEMBER
4 - RUBBER MOUNTS
5 - RETAINING CLAMP
INSTALLA TION
(1) Con n ect h ood r elea se ca ble a n d in st a ll cr oss-
m em ber.
(2) In st a ll cr ossm em ber bolt s a n d t igh t en t o 14
N·m (10 ft . lbs.).
(3) In st a ll r u bber m ou n t s a n d r et a in in g cla m ps.
(4) In st a ll h ea t sh ield.
(5) In st a ll h ea dla m ps. (Refer t o 8 - E LE CTRICAL/
LAMP S/LIGH TING -
UNIT - INSTALLATION)
(6) In st a ll gr ille. (Refer t o 23 - BODY/E XTE RIOR/
GRILLE - INSTALLATION)
SI DE V I EW M I RROR
REMOVAL
Driver's Side
(1) Discon n ect a n d isola t e ba t t er y n ega t ive ca ble.
(2) Rem ove t r im plu g. (F ig. 3)
- E XTE RIOR/F RONT
a n d discon n ect
E XTE RIOR/F RONT
NOTE: If the vehicle is not equipped with power
mirrors, skip to step 5.
(3) Rem ove t r im pa n el. (Refer t o 23 - BODY/DOOR
- F RONT/TRIM PANE L - RE MOVAL)
(4) Rem ove t a pe, expose elect r ica l con n ect or a n d
discon n ect . (F ig. 3)
(5) Rem ove bolt s a n d r em ove m ir r or.
(6) If equ ipped, P u ll wir e h a r n ess t h r ou gh .
h ood
Fig. 3 DRIVERS SIDE MIRROR
1 - ELECTRICAL CONNECTOR
2 - MIRROR
3 - EXTERIOR BOLTS
4 - INNER BOLT
5 - TRIM PLUG
6 - TAPE

Passenger Side

(1) Discon n ect a n d isola t e ba t t er y n ega t ive ca ble.
(2) Rem ove t r im plu g. (F ig. 4)
NOTE: If the vehicle is not equipped with power
mirrors, skip to step 5.
(3) Sepa r a t e du st boot fr om a -pilla r.
(4) Discon n ect t h e elect r ica l con n ect or.
(5) Rem ove bolt s a n d r em ove m ir r or.
(6) If equ ipped, pu ll wir e h a r n ess t h r ou gh .
LAMP
EXTERIOR 23 - 49