Dodge Sprinter 2006 Manual page 1890

21 - 152 AUTOMA TIC TRANSMISSION NAG1 - SERVICE INFORMA TION
Fig. 179 B2 Piston and Piston Guide Ring
1 - VALVE
2 - PISTON GUIDE RING
3 - B2 PISTON
(4) In ser t pist on gu ide r in g (2) (F ig. 179). Th e
va lve (1) in t h e pist on gu ide r in g m u st be on t op.
(5) In ser t disc spr in g (14) (F ig. 178) a n d spr in g
pla t e (15). In ser t disc spr in g wit h t h e cu r va t u r e
t owa r ds t h e spr in g pla t e
(6) P la ce Mu lt i-u se Spr in g Com pr essor 8900 on t h e
disc spr in g (14) a n d com pr ess t h e spr in g u n t il t h e
gr oove for t h e sn a p-r in g is exposed.
(7) In ser t sn a p-r in g (16).
NOTE: Pay attention to sequence of discs. If the
original clutch discs are reused, be sure to return
the disc identified on disassembly as belonging on
top of the disc spring (3) to its original location.
Place new friction multiple-discs in ATF fluid for
one hour before installing.
(8) In ser t disc spr in g (3) a n d m u lt iple-disc pa ck (2)
in t h e B2 ou t er m u lt iple-disc ca r r ier.
(9) In ser t sn a p-r in g (1).
Fig. 180 Measure B2 Clutch Clearance
1 - PRESSING TOOL 8901
2 - B3 PISTON/B2 OUTER DISC CARRIER
NOTE: During the measurement the snap-ring (8)
must contact the upper bearing surface of the
groove in the outer multiple-disc carrier.
(10) Mea su r e t h e B2 clu t ch pa ck clea r a n ce by
m ou n t in g t h e P r essin g Tool 8901 (1) (F ig. 180) on
ou t er m u lt iple disc.
(11) Usin g a lever pr ess, com pr ess t h e pr essin g
t ool a s fa r a s t h e st op (t h en t h e m a r kin g r in g is st ill
visible, see sm a ll a r r ow).
VA