Introduction
Connecting the Ethernet ports
The following section provides information on connecting the Ethernet ports on the back of the
media server.
You connect to the various ports using standard CAT5 cables with RJ45 connectors on each
end. If the S8500 Media Server has only one port network, connect it through the dual NIC.
Figure 2: Avaya S8500 Media Server connectivity guide
S8500 Media Server.
Figure 2: Avaya S8500 Media Server connectivity guide
Figure notes:
1. Eth0—to customer's network if
nondedicated control network.
(straight-through CAT5 cable)
2. Eth1—to services laptop (cross-connect
CAT5 cable)
Connecting the modems
On an S8500 Media Server, there is a modem that connects to the USB port on the SAMP. If
you have not connected the modem yet, do so now.
Note:
USB modems cannot connect to rotary lines. A Touch Tone line is required.
Note:
26 Installing and Configuring the Avaya S8500 Media Server
2
1
1
2
1
2
3. Eth2—to port network if only one port
network (cross-connect CAT5 cable) or to
customer's network if dedicated control
network (straight-through CAT5 cable)
4. Eth3—unused
shows typical connectivity for the
4
h3msbl5a KLC 093004
3