012-700 Punch Box Nearly Full Rap (Lx); 012-901 H-Transport Entrance Sensor Static Jam Rap (Lx) - Xerox workcentre 5335 series Service Manual

012-700 Punch Box Nearly Full RAP (LX)

BSD-ON: BSD 12.15 - Office Finisher LX Punch
Punch Box nearly full.
Procedure
Empty the Punch Box and re-insert. If the fault remains, check the circuit of the Punch Box Set
Sensor.
Status Indicator RAPs
012-700, 012-901

012-901 H-Transport Entrance Sensor Static Jam RAP (LX)

BSD-ON: BSD 12.14 - Office Finisher LX Horizontal Transportation
Paper remains on the H-Transport Entrance Sensor.
Initial Actions
Check the paper path. If no paper is found continue with this RAP.
Clean the sensor.
Procedure
Execute Component Control
Entrance Sensor
Y N
Check the wire between
loose or damaged connector. The wire is OK.
Y N
Repair/reconnect as required.
Measure the voltage between J8897, pins 4 and 5 on the Finisher PWB
Office Finisher LX Horizontal
Y N
Replace the Finisher PWB
Measure the voltage between J8897, pin 6 on the Finisher PWB and GND
Office Finisher LX Horizontal
sor. The voltage changes.
Y N
Replace the H-Transport Entrance Sensor
Replace the Finisher PWB
If the problem continues, replace the Finisher PWB
07/2011
2-128
BUS Updated 12/2011
[012-190], H-Transport Entrance Sensor. Actuate the H-Transport
(PL 23.4). The display changes.
J8861 pin 2 and J8897 pin 6 for an open or short circuit, or a
Transportation). The voltage is approx. +5VDC.
(PL 23.16).
Transportation. Actuate the H-Transport Entrance Sen-
(PL 23.4).
(PL 23.16).
(PL 23.16).
WorkCentre 5335 Family Service Documentation
(BSD 12.14 -
BSD 12.14 -
Initial Issue