Table of Contents
Advertisement
005-139 DADF Invert Sensor Off Jam RAP
BSD-ON:
BSD 5.1 - Document Setting
BSD-ON:
BSD 5.6 - Document Scan and Invert
•
After the DADF Registration Sensor turned OFF in the Scan operation, the DADF Invert
Sensor did not turn OFF within the specified time.
•
During the 1 Sided mode scan operation where there is a next document, after the Next
Document Scan Read Speed Control started (DADF Registration Motor On (CCW)), the
DADF Inverter Sensor did not turn OFF within the specified time.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
Transportation failure due to foreign substance in the document path
•
The surface of the roll for foreign substance
•
The surface of the roll for wear
•
Check the sw version of the controller sw - update if required.
•
The Gate Solenoid
Component Control
•
DADF Registration Motor:
Component Control
•
Check if the Exit Roll is nipping properly. (Including the operations of Exit Nip Release
Solenoid
(Component Control
[005-072]))
•
Check the circuit between the DADF Registration Sensor and the DADF PWB
•
DADF Registration Sensor:
Component Control
•
Check the circuit between the DADF Inverter Sensor and the DADF PWB
•
DADF Invert Sensor:
Component Control
•
DADF PWB failure.
(PL
51.2)
Initial Issue
WorkCentre 5335 Family Service Documentation
[005-090] for operation failure
[005-033]
(PL
51.5)
(PL
51.6)
[005-110]
(PL
51.17)
[005-211]
(PL
51.9)
BUS Updated 12/2011
005-145 DADF Registration Sensor Off Jam (Invert) RAP
BSD-ON:
BSD 5.5 - Document Feed (2 of 2)
BSD-ON:
BSD 5.6 - Document Scan and Invert
After the DADF Pre Registration Sensor turned OFF at Invert, the DADF Registration Sensor
did not turn OFF within the specified time.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
Transportation failure due to foreign substance in the document path
•
The surface of the roll for foreign substance
•
The surface of the roll for wear
•
Check the sw version of the controller sw - update if required.
•
DADF Registration Motor:
Component Control
•
DADF Feed Motor:
Component Control
•
Check the circuit between the DADF Registration Sensor and the DADF PWB
•
DADF Registration Sensor:
Component Control
•
Check the circuit between the DADF Pre Registration Sensor and the DADF PWB
•
DADF Pre Registration Sensor:
•
DADF PWB failure.
(PL
51.2)
07/2011
2-69
[005-033]
(PL
51.5)
[005-008]
(PL
51.5)
[005-110]
(PL
51.17)
Component Control
[005-206]
(PL
51.17)
Status Indicator RAPs
005-139, 005-145
Advertisement
Table of Contents
