003-757 400Dpi Cannot Be Scanned Rap; 003-760 Scan Settings Rap - Xerox workcentre 5335 series Service Manual

003-757 400dpi Cannot be Scanned RAP

BSD-ON: BSD 3.5 - ESS-DADF Communication
This status code is displayed if over 400dpi cannot be scanned (DADF). 400/600dpi disabled
for DADF Mix Duplex Mode Scan.
Procedure
• Perform scan with 300dpi or lower resolution or change the job to that scannable with
NON-MIX mode.
• If powering OFF then ON does not resolve the problem, perform the following:
1. Check the cable between IIT PWB and ESS PWB
nected to them (RAM, Firmware module, EEPROM).
2. Check the sw version of the controller sw - reload Software
3. Replace IIT PWB (Switch the EEPROM)
4. Replace ESS PWB (PL 35.2).
Status Indicator RAPs
003-757, 003-760
(PL 35.2), MCU all PWBs con-
(GP 16)
(PL 1.6)
BUS Updated 12/2011

003-760 Scan Settings RAP

BSD-ON: BSD 3.5 - ESS-DADF Communication
The job properties are incorrect.
Procedure
• Abort the job. Change Job Startup parameters such as Tray No., Paper size etc. and retry.
• Disconnect then reconnect the IIT, ESS, MCU all PWBs connected to them (RAM, Firm-
ware module, EEPROM)
• Check the sw version of the controller sw - reload Software
• Replace IIT PWB (Switch the EEPROM)
07/2011
2-42
(GP 16)
(PL 1.6)
Initial Issue
WorkCentre 5335 Family Service Documentation