Punch Home Sensor Fail Rap - Xerox VersaLink B7025 Service Manual

A B
Y N
Check the +24VDC circuit. Refer to the
install a new finisher PWB,
Install a new finisher PWB, PL 13.45 Item
Check the wiring between J8984 pins 13 to 17 on the finisher PWB, and the rear tamper
motor P/J8883 for an open or short circuit, or a loose or damaged connector. The wir-
ing is good.
Y N
Reconnect or repair as necessary.
Install a new rear tamper motor, PL 13.28 Item
PWB, PL 13.45 Item 2.
Install a new finisher PWB, PL 13.45 Item
Status Indicator RAPs
012-224B, 012-263B, 012-231
Wiring Diagrams. If the fault persists,
PL 13.45 Item 2.
2.
8. If the fault persists, install a new finisher
2.

012-231 Punch Home Sensor Fail RAP

BSD-ON: BSD 13.6 Office Finisher LX Punch
012-231 The punch home sensor did not turn on within the specified time after the punch motor
started running.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP
death or injury. Moving parts can cause injury.
• Check the punch home actuator for deformation.
• Check the punch home sensor,
Procedure
Enter dC330 code 12-074 and 12-078 alternately to run the punch motor. The punch motor
runs.
Y N
Check the wiring to the punch motor. Install new components as necessary:
• Punch motor, PL 13.09 Item
• Finisher PWB, PL 13.45 Item
Enter dC330 code 12-271. Use a piece of paper to actuate the punch home sensor. The dis-
play changes.
Y N
Check the wiring to the punch motor. Install new components as necessary:
• Punch home sensor, PL 13.09 Item
• Finisher PWB, PL 13.45 Item
If the fault persists, install a new finisher PWB,
April 2017
2-88 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
10. Disconnect the power cord. Electricity can cause
PL 13.09 Item 5 for proper installation.
1.
2.
5.
2.
PL 13.45 Item 2.
Launch Issue