Table of Contents
Advertisement
016-734 Destination Report Output Error RAP
Destination Result report output has failed.
Procedure
1.
Set [Receive via SMTP] for E-mail receive setting on the sending device.
2.
Remove the restriction on receiving E-mails from a self-domain in the receivable domain
list if any.
If the problem persists, perform the following procedures in sequence to repair it.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firm-
ware module, EEPROM)
•
Check the sw version of the controller sw - update if required
Status Indicator RAPs
016-734, 016-735
016-735 Updating Job Template RAP
The system attempted to output the Job Template List while the Job Template was being
updated.
Initial Actions
Power Off/On
Procedure
•
Ask customer to cancel and rerun the job.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
07/2011
2-246
BUS Updated 12/2011
Initial Issue
WorkCentre 5335 Family Service Documentation
Advertisement
Table of Contents
