003-941 Page Memory Insufficient Rap; 003-942 Document Size Auto Detect Rap - Xerox workcentre 5335 series Service Manual

003-941 Page Memory Insufficient RAP

A shortage of page memory. There is not enough page memory to store the image.
Procedure
• Change the parameter(s) and operate again.
• If the problem persists, check that the Page Memory
then ON the power.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - reload Software
• Reseat/Replace Page Memory (PL 35.2).
Initial Issue
WorkCentre 5335 Family Service Documentation

003-942 Document Size Auto Detect RAP

BSD-ON:BSD 5.2 - Document Size Sensing (1 of 2)
The document size cannot be automatically detected.
Initial Actions
(PL 35.2) is installed and turn OFF
•
•
(GP 16)
•
•
Procedure
Execute
display changes.
Y
Execute
display changes.
Y
A
07/2011
2-49
BUS Updated 12/2011
If the document in question is a non-standard size, ask customer to manually set the doc-
ument size. If the fault occurs with standard size documents, continue with the procedure.
Check fault history for occurrences of 005-194, 005-196, or
any of these faults first.
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
Check the sw version of the controller sw - reload Software
Component Control [005-221]. Block and unblock the DADF Tray Size 1 Sensor. The
N
Check the wires between P/J756 and P/J761
aged or loose connector. The wires are OK.
Y N
Repair as required.
There is approx. +5VDC between P/J756
Y N
Replace the DADF PWB (PL 51.2).
Measure the voltage between P/J756 pin 2 on the DADF PWB and GND (-). Block and
unblock the DADF Tray Size 1 Sensor. The voltage changes.
Y N
Replace the DADF Tray Size 1 Sensor
Replace the DADF PWB (PL 51.2).
Component Control [005-222]. Block and unblock the DADF Tray Size 2 Sensor. The
N
Check the wires between P/J756 and P/J764
aged or loose connector. The wires are OK.
Y N
Repair as required.
Measure the voltage between the DADF PWB P/J756-6 (+) and GND (-). The voltage is
approx. +5VDC.
Y N
Replace the DADF PWB (PL 51.2).
Measure the voltage between the DADF PWB P/J756-5 (+) and GND (-). Actuate the
DADF Tray Size 2 Sensor with paper. The voltage changes.
005-197 faults. Troubleshoot
(GP 16)
for an open or shorted circuit or a dam-
pin 3 on the DADF PWB and GND.
(PL 51.10).
for an open or shorted circuit or a dam-
Status Indicator RAPs
003-941, 003-942