Table of Contents
Advertisement
003-978 Color Document Mismatch RAP
Color Document Mismatch (Multi Scan).
1.
Document replacement was detected during Bound Originals/Booklet/Poster scanning
2.
When any operation that requires Return Document occurs in the job with Multi Scan
(Bound Originals/Booklet/Poster) on Platen, a user returned a document of a different
color at ACS.
Procedure
•
Reload a correct size paper and resume operation.
•
If powering OFF then ON does not resolve the problem, perform the following:
1.
Disconnect then reconnect the harness between the IIT PWB and ESS, MCU all
PWBs connected to them (RAM, Firmware module, EEPROM)
2.
Check the sw version of the controller sw - reload Software
3.
Replace IIT PWB (Switch the EEPROM)
4.
Replace ESS PWB
(PL
35.2).
Status Indicator RAPs
003-978, 003-980
(GP
16)
(PL
1.6).
BUS Updated 12/2011
003-980 Staple Position RAP
Stapling could not be done at the specified position.
Procedure
•
Specify a Staple position again or cancel Staple, and execute the same job again.
•
Disconnect then reconnect the harness between the IIT PWB and ESS, MCU all PWBs
connected to them (RAM, Firmware module, EEPROM)
•
Check the sw version of the controller sw - reload Software
07/2011
2-60
(GP
16)
Initial Issue
WorkCentre 5335 Family Service Documentation
Advertisement
Table of Contents
