Table of Contents
Advertisement
016-782 Scan Server Login Error RAP
A failure in logging in to the server to transfer a file to it.
<FTP>
Failed to log into FTP server
<SMB>
Failed to log into SMB server.
Also occurs in SMB when the network cable is disconnected
Procedure
Perform the following procedures:
1.
For SMB, first check the connection of the network cable. If that does not solve it,
proceed as follows.
2.
As EUC Code (Japanese) cannot be used in the hostname of the current specifica-
tion, change it to English.
3.
Register the job flow from EasyAdmin.
Now even if the hostname is in EUC Code (Japanese), transfer is possible.
4.
Check the "Server Name/IP Address" at the address display.
WinNT4.0: Because SMB transfer to WinNT4.0 is not possible with IP Address,
change the "Server Name/IP Address" to Hostname.
WinXP: Can SMB transfer normally even with IP Address.
5.
In the default settings of WinXP, empty password cannot be used for access though
the network.
Change the WinXP settings to "Allow Empty Password Access" and operate again.
6.
Set a login name and a password at the Destination Server.
7.
Make correct settings for the attributes of the Job Template file.
8.
At the CW, set the same account as above as a resource in the client PC.
Status Indicator RAPs
016-782, 016-783
016-783 Invalid Server Path RAP
When transferring a file to the server, a selected path is not found.
<FTP>
"CWD" command failure of output directory specified in DocumentPath attributes. Either
the specified path does not exist, or no access right
<SMB>
Either the specified path does not exist, or no access right
Procedure
1.
Make correct settings for the attributes of the Job Template file.
2.
Check the server path name set in the Job Template and set up again.
07/2011
2-270
BUS Updated 12/2011
Initial Issue
WorkCentre 5335 Family Service Documentation
Advertisement
Table of Contents
