012-231 Punch Home Sensor On Fail Rap (Lx) - Xerox workcentre 5335 series Service Manual

A
Y N
Repair/reconnect as required.
Replace the Rear Tamper Motor (PL
PWB (PL 23.16).
Replace the Finisher PWB (PL 23.16).
Initial Issue
WorkCentre 5335 Family Service Documentation
23.12). If the problem persists, replace the Finisher
BUS Updated 12/2011

012-231 Punch Home Sensor On Fail RAP (LX)

BSD-ON: BSD 12.15 - Office Finisher LX Punch
The Punch Home Sensor did not turn ON within the specified time after the Punch Motor
started running.
Initial Actions
Check the following:
• Punch Home Actuator for deformation
• Punch Home Sensor for proper installation
• Punch Home Sensor connectors
• Punch Motor for proper operation
• Punch Motor connectors
Procedure
Enter Component Control [12-074] and [12-078], Punch Motor
Start. The Punch Motor runs.
Y N
Select Stop. Check circuit of the Punch Motor. Refer to
Punch to troubleshoot the Circuit.
Select Stop. Select [12-271], Punch Home Sensor
with a piece of paper. The display changes.
Y N
Go to BSD 12.15 - Office Finisher LX
Select Stop. If the problem continues, replace the Finisher PWB
07/2011
2-115
(PL 23.5), alternately. Select
BSD 12.15 - Office Finisher LX
(PL 23.5). Select Start. Actuate the sensor
Punch. Check circuit of the Punch Home Sensor.
(PL 23.16).
Status Indicator RAPs
012-224, 012-231