016-736 Remote Directory Lock Error Rap; 016-737 Remote Lock Directory Remove Error Rap - Xerox workcentre 5335 series Service Manual

016-736 Remote Directory Lock Error RAP

Creation of Lock directories has failed
Procedure
1. Delete any existing lock directories (*.LCK) in the transfer destination manually and then
execute the job again.
2. Make correct settings for the permissions to the transfer destination directories.
3. Secure a disk capacity if the HDD for the transfer destination directory is full.
If the problem persists, perform the following procedure to repair it.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firm-
ware module, EEPROM)
• Check the sw version of the controller sw - update if required
Initial Issue
WorkCentre 5335 Family Service Documentation

016-737 Remote Lock Directory Remove Error RAP

Failed to delete the Lock directory. Power was turned OFF in the middle of FTP transfer
because the CDI cable was disconnected or the Reset SW of DFE was actuated.
Procedure
• Delete any existing lock directories (*.LCK) in the transfer destination manually and then
execute the job again.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
07/2011
2-247
BUS Updated 12/2011
Status Indicator RAPs
016-736, 016-737