012-269 Booklet Sub-Cpu Communications Fail Rap (Lx); 012-282 Eject Clamp Home Sensor Off Failure Rap (Lx) - Xerox workcentre 5335 series Service Manual

012-269 Booklet Sub-CPU Communications Fail RAP (LX)

BSD-ON:
Communications between the Finisher PWB and the Booklet PWB Failed
Initial Actions
• Check the connectors at the Finisher PWB and the Booklet PWB are connected or seated
properly
• Check the wiring between the Finisher PWB and the Booklet PWB for damage
Procedure
Power off and power on the printer. Execute
Detected. The problem is resolved.
Y N
Reload the software. The problem is resolved.
Y N
Replace the Finisher PWB (PL
PWB (PL 23.21).
Rerun the job.
Rerun the job.
Status Indicator RAPs
012-269, 012-282
Component Control [013-161], Booklet Maker
23.16). If the problem continues, replace the Booklet
BUS Updated 12/2011

012-282 Eject Clamp Home Sensor Off Failure RAP (LX)

BSD-ON: BSD 12.22 - Office Finisher LX Eject Control (1 of 2)
After the Eject Clamp started descending, the Eject Clamp Home Sensor did not turn Off within
200ms.
Initial Actions
• Manually operate the Eject mechanism. Check for binding, a dirty sensor, or damage.
• Check the actuator for the Eject Clamp Home Sensor for damage
Procedure
Execute Component Control [012-250], Eject Clamp Home Sensor. Block and unblock the
Eject Clamp Home Sensor The display changes.
Y N
Check the wire between J8870
8 on the Finisher PWB for an open or short circuit, or loose or damaged connectors. The
wire is OK.
Y N
Repair/replace as required.
Measure the voltage between P/J8988, pins 9 and 7 on the Finisher PWB. The voltage
is approx. +5VDC.
Y N
Replace the Finisher PWB
Measure the voltage between
Eject Clamp Home Sensor. The voltage changes.
Y N
Replace the Eject Clamp Home Sensor
Replace the Finisher PWB (PL
Alternately execute Component Control
Down. The Eject Motor starts.
Y N
Check the wires between P/J8878
the Finisher PWB for an open or short circuit, or loose or damaged connectors
- Office Finisher LX Eject Control (1 of
Y N
Repair/replace as required.
Measure the resistance of the Eject Motor between each pin of P/J8878-1/3/4/6. The
resistance is approx. 2Ohm.
Y N
Replace the Eject Motor (PL
Replace the Finisher PWB (PL
(PL 23.11)
A
07/2011
2-120
pin 2 on the Eject Clamp Home Sensor and
(PL 23.16).
P/J8988 pin 8 on the Finisher PWB and GND. Actuate the
(PL 23.11).
23.16).
[012-052], Eject Clamp Up and [012-053], Eject Clamp
pins 1~6 on the Eject Motor and P/J8983
2). The wires are OK.
23.11).
23.16). If the problem remains, replace the Eject Motor
WorkCentre 5335 Family Service Documentation
P/J8988 pin
pins 5~8 on
BSD 12.22
Initial Issue