005-942 Doc Fault Loading On Dadf Rap; 005-945 Fs-Size Mismatch Jam On No Mix-Size Or Ss Mix-Size (Cont) Rap - Xerox workcentre 5335 series Service Manual

005-942 Doc Fault Loading on DADF RAP

Operation Fail. DADF-loaded documents Fail (DADF-250). When the Nudger Solenoid is
turned ON to return at the start of a job, it is detected that the Level Sensor does not turn OFF.
Procedure
1. Reduce documents in number and reload a smaller number of them.
Status Indicator RAPs
005-942, 005-945
005-945 FS-Size Mismatch Jam On No Mix-Size or SS Mix-
Size (Cont) RAP
BSD-ON: BSD 5.3 Document Size Sensing (2 of 2)
BSD-ON: BSD 5.4 - Document Feed (1 of 2)
In No Mix or Slow Scan (SS) Mixed mode, it was detected that a document with a different size
in Fast Scan (FS) direction was transported from the DADF. (If paper was not fed, 005-945 is
displayed. If paper was fed, 005-947 is displayed.)
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
• Check the sw version of the controller sw - update if required
• Check that the DADF Tray Set Guide operates normally.
• DADF Tray Set Guide Sensors 1-3:
• Check the circuit between the DADF Tray Set Guide Sensors 1-3 and the DADF PWB
• DADF APS Sensors 1-3:
• Check the circuit between the DADF APS Sensors 1-3 and the DADF PWB.
• Change the system data 700-530 to "0" and disable the automatic startup boot operation
at System Fail (make sure to reset to 1 when complete
• If no problems are found, replace the DADF PWB
07/2011
2-80
BUS Updated 12/2011
Component Control [005-215/216/217]
Component Control [005-218/219/220] (PL
(PL 51.2).
WorkCentre 5335 Family Service Documentation
(PL 51.10)
51.17)
Initial Issue