012-302 Finisher Front Cover Open Rap (Lx); 012-303 Finisher H-Transport Cover Open Rap (Lx) - Xerox workcentre 5335 series Service Manual

012-302 Finisher Front Cover Open RAP (LX)

BSD-ON: BSD 12.12 - Office Finisher LX Interlock Switching
The Finisher Front Cover is open.
Initial Actions
• Check the installation of the H-Transport Open Sensor
• Opening/closing of the Finisher H-Transport Cover.
Procedure
Execute Component Control [012-302], Front Door Interlock Switch. Open/close the Finisher
Front Cover. The display changes.
Y N
Open the Front Door and cheat the Front Door Interlock Switch The display changes.
Y N
Check the wires between J8982
J8982 pin 2 for an open or short circuit, or a loose or damaged connector.
wires are OK.
Y N
Repair/reconnect as required.
Remove the cheater. Measure the voltage between
Interlock Switch and GND (BSD 12.12 - Office Finisher LX Interlock
The voltage is approx. +5VDC.
Y N
Check the wire from J8891
or a loose or damaged connector. If the wires are OK, replace the Finisher
PWB (PL 23.16).
Cheat the Interlock Switch. The voltage drops to 0 VDC.
Y N
Replace the Front Door Interlock Switch
Replace the Finisher PWB (PL
Check the actuator for damage or misalignment
Check the Interlock circuit for an intermittent condition
lock Switching If the problem continues, replace the Finisher PWB
Status Indicator RAPs
012-302 , 012-303
pin 3 and J8891 pin 2B, and from J8891
J8891 pin 2A on the Front Door
Switching).
pin 2A to J8982 pin 3 for an open or short circuit,
(PL 23.16).
23.16).
BSD 12.12 - Office Finisher LX Inter-
(PL 23.16).
BUS Updated 12/2011

012-303 Finisher H-Transport Cover Open RAP (LX)

BSD-ON: BSD 12.14 - Office Finisher LX Horizontal Transportation
The Finisher H-Transport Cover is open.
Initial Actions
• Check the installation of the H-Transport Open Sensor
• Opening/closing of the Finisher H-Transport Cover.
Procedure
Execute Component Control
Open Sensor (PL 23.4). The display changes.
Y N
Check the wire between
loose or damaged connector. The wire is OK.
pin 2A to Y N
The Repair/reconnect as required.
Measure the voltage between J8897, pins 3 and 1 on the Finisher PWB
Office Finisher LX Horizontal
Y N
Replace the Finisher PWB
Measure the voltage between J8897, pin 2 on the Finisher PWB and GND
Office Finisher LX Horizontal
The voltage changes.
Y N
Replace the H-Transport Open Sensor
Replace the Finisher PWB
If the problem continues, replace the Finisher PWB
07/2011
2-126
[012-303], H-Transport Open Sensor. Actuate the H-Transport
J8860 pin 2 and J8897 pin 2 for an open or short circuit, or a
Transportation. The voltage is approx. +5VDC.
(PL 23.16).
Transportation). Actuate the H-Transport Open Sensor.
(PL 23.4).
(PL 23.16).
(PL 23.16).
WorkCentre 5335 Family Service Documentation
(BSD 12.14 -
(BSD 12.14 -
Initial Issue