Dodge RAM TRUCK 1500 1995 Service Manual page 520

13
R
POWER MIRRORS 8T - 3
(6) Place transmission gear selector in Neutral.
Place mirror switch in ON (switch lighted) position.
Cover the forward facing sensor to keep out any am­
bient light. Light sensor must be covered com­
pletely so that no light reaches the sensor. Use
only one finger pressed tightly against sensor,
or cover sensor completely with electrical tape.
(7) Shine a light into the rear facing sensor. The
mirror should darken. If OK, go to next step. If not
OK, replace mirror
(8) With the mirror darkened, place the transmis­
sion gear selector in Reverse. The mirror should re­
turn to its normal condition. If not OK, replace
mirror.
S E R V I C E
P R O C E D U R E S
POWER MIRROR SWITCH REMOVE/INSTALL
(1) Remove 2 screws and door pull cup (Fig. 5).
REMOVE 2 SCREWS
J948S-2
Fig. 5 Door Pull Cup
(2) Remove power window/lock switch by reaching
through door pull cup opening and depressing rear
switch retaining tab (Fig. 6).
Fig. 6 Switch Bezel Rear Retaining Tab
(3) Pull rear of switch up and away from door.
(4) Unplug connectors from switch (Fig. 7).
(5) Pull power mirror switch control knob rearward
to remove from switch (Fig. 8).
(6) Remove switch retaining nut from switch (Fig.
9).
To aid in removal of the trim panel, start at
the bottom of the panel.
(7) Using a wide flat-bladed tool such as a trim
stick, pry trim panel away from door around perime­
ter and remove trim panel.
(8) Unplug power mirror switch connector (Fig.
10).
Fig. 8 Power Mirror Knob Remove/Install
(9) To install switch, mount into trim panel using
retaining nut (Fig. 9).
(10) Plug switch connector together (Fig. 10).
(11) Place trim panel in position and press in nylon
retainers.
(12) Install power mirror switch control knob by
pushing onto control stem.
(13) Place front of door switch panel into opening.
Press rear of switch panel into place.
(14) Install door pull cup.