Dodge RAM TRUCK 1500 1995 Service Manual page 511

POWER SEAT SWITCH CONTINUITY
SWITCH POSITION
CONTINUITY BETWEEN
OFF
B-N, B-J, B-M,
B-E, B-L, B-K
VERTICAL UP
A-E, A-M, B-N, B-J
VERTICAL D O W N
A-J,
A - N , B-M, B-E
HORIZONTAL FORWARD
A-L,
B-K
HORIZONTAL AFT A-K, B-L
FRONT TILT UP
A-M,
B-N
FRONT TILT D O W N A - N , B-M
REAR TILT UP
A-E, B-J
REAR TILT D O W N A-J, B-E
(2) Remove switch mounting screws and check for
battery voltage at red/light blue wire of switch con­
nector. If OK, go to next step. If not OK, repair wir­
ing to circuit breaker.
(3) Check for continuity between black/orange wire
at switch connector and a good ground. There should
be continuity. If OK, replace faulty switch. If not OK,
repair wiring to ground.
AFT/FORWARD — •
DOWN
TERMINALS SHOWN AS VIEWED
FROM REAR OF SWITCH
908R-4
POWER SEAT SWITCH
To check the power seat switch, remove the switch
from its mounting position. Use an ohmmeter and
see the Power Seat Switch Continuity chart. Deter­
mine if switch continuity is correct. If OK, see Power
Seat Adjuster/Motors diagnosis. If not OK, replace
faulty switch assembly.