(2) Remove 3 screws holding sensor to front wheel-
house extension. Remove sensor (Fig. 14).
RIGHT IMPACT
SENSOR
J948M-5
Fig. 14 Right impact Sensor
Do not remove tape holding harness to con
nector.
(3) Unplug connector from sensor and remove sen
sor (Fig. 15).
IMPACT
SENSOR
SENSOR
CONNECTOR
J948M-8
Fig. 15 Impact Sensor Connector - Typical
(4) To install, connect sensor wiring lead from har
ness to connector on body of sensor.
(5) Mount sensor (arrow pointed forward) using 3
screws provided with new sensor. Tighten screws to 4
- 5 N-m (35 - 45 in. lbs.).
(6) Do not connect negative battery cable at this
time. See Airbag System Check for proper procedure.
¥-11 AND DIESEL EN11NE
(1) Disconnect battery negative cable and isolate.
If airbag module is undeployed, wait 2 minutes for
system capacitor to discharge before further service.
(2) Remove 3 screws holding sensor to front wheel-
house extension. Remove sensor (Fig. 14).
Do not remove tape holding harness to con
nector.
(3) Unplug connector from sensor and remove sen
sor (Fig. 15).
(4) To install, connect sensor wiring lead from har
ness to connector on body of sensor.
(5) Mount sensor (arrow pointed forward) using 3
screws provided with new sensor. Tighten screws to 4
- 5 N-m (35 - 45 in. lbs.).
(6) Do not connect negative battery cable at this
time. See Airbag System Check for proper procedure.
AIRBAG CONTROL MODULE REMOVE/INSTALL
WARNING: THE ACM CONTAINS ONE O F THE IM
PACT S E N S O R S WHICH E N A B L E THE S Y S T E M TO
DEPLOY THE A I R B A G . TO AVOID ACCIDENTAL DE
PLOYMENT, N E V E R CONNECT ACM ELECTRICALLY
TO THE SYSTEM U N L E S S IT S S BOLTED TO VEHI
C L E . BEFORE BEGINNING ANY A I R B A G SYSTEM
REMOVAL OR INSTALLATION P R O C E D U R E S , RE-
i l Q V E AND ISOLATE THE BATTERY NEGATIVE (-)
C A B L E FROM THE VEHICLE BATTERY. THEN WAIT
2 MINUTES F O R S Y S T E M CAPACITOR TO DIS
CHARGE B E F O R E FURTHER SYSTEM S E R V I C E .
THIS IS THE ONLY S U R E W A Y TO DISABLE THE
A I R B A G S Y S T E M . FAILURE TO DO THIS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT,
AND P O S S I B L E P E R S O N A L I N J U R Y
(1) Disconnect battery negative cable and isolate.
If airbag is undeployed, wait 2 minutes for system
capacitor to discharge before further service.
(2) Remove 2 screws and cover from bottom of cen
ter console (Fig. 16).
AIRBAG
CONTROL
MODULE
COVER
.INSTRUMENT
PANEL
TRANSMISSION
TUNNEL
J948M-1
Fig. 16 Airbag Control Module Cover Screws
(3) Remove 4 screws holding ACM to transmission
tunnel (Fig. 17).
(4) Disconnect wiring at ACM.
(5) Remove ACM.
(6) To install, position the ACM with the arrow
pointing forward.