Optional Barcode Check Function Configuration - SATO CL4NX Operator's Manual

7.6 Optional Barcode Check Function
Configuration
7.6.1 Basic Specifications of the Barcode Check Function
The barcode check function does a reading check of a barcode printed by this printer to prevent the
distribution of labels with defective barcodes. You can use this function by installing the supported
barcode checkers to the printer.
The basic specifications of the barcode check function are as follows:
Item
Supported Barcode
Checkers
Supported SBPL/SZPL/SIPL/STCL/SDPL/SEPL
Commands *AEP is not supported.
Supported Print Continuous/Cutter/Cut & Print/Dispenser/Linerless (CL4NX only)
Modes *Not available in Tear-Off mode.
*Not available for CL4NX RFID models.
*The Void Print function is not available in Dispenser/Linerless (CL4NX only) mode.
Print Speed/ The optimal print speed and print darkness for secure reading vary depending on
Print Darkness various conditions, such as the barcode type and label layout. Be sure to perform a
test read carefully and determine the settings.
Printable Area Same as the printer specifications. However, there are following restrictions:
(Barcode Readable Continuous mode:
Area) Barcodes printed within the range of 11 mm (0.43") from the trailing end of the label
cannot be read because it is blocked by the print head and ribbon adjustment plate.
• IDEC/DATALOGIC WB1F-100S1S (for 1D barcodes, USB connection)
• IDEC/DATALOGIC GFS4470 (for 1D barcodes/2D codes, USB connection)
• KEYENCE BL-1301 (for 1D barcodes, RS-232C connection)
• KEYENCE SR-710 (for 1D barcodes/2D codes, RS-232C connection)
Ribbon
adjustment
plate
Print head
Specification
Readable area (for the
minimum media pitch)
(9 mm (0.35"))
Unreadable area
11 mm (0.43")
CL4NX/CL6NX Operator Manual
7 Appendix
Minimum
media pitch
20 mm (0.79")
333