SATO CL4NX Operator's Manual page 321

5
Press the lever w to remove the print
head e.
CAUTION (for CL4NX only)
For UHF RFID models, the UHF RFID antenna is
installed on the print head. Be careful not to overly
pull the antenna cable when replacing the print head.
Contact your SATO reseller or technical support
center for more information.
6
Disconnect all the connectors r from
the defective print head e.
In total, there are two connectors for CL4NX and
three connectors for CL6NX.
7
Connect all the connectors r to the
new print head.
CAUTION
Handle the print head with care.
Do not contaminate or scratch the sensitive print head
surface.
8
Install the new print head.
Install the print head so that it is locked with a click sound.
9
Load the media and ribbon back if you remove them in step 4.
Refer to Section 3.5 Loading Media and Section 3.2 Loading the
7 Appendix
Ribbon.
CL4NX/CL6NX Operator Manual
2
3
4
3
319