SATO CL4NX Operator's Manual page 237

Host Notification
Tools > Barcode Checker > Settings > Host Notification
Set whether to return the barcode check results to the host from which the
print data is sent.
The options are as follows:
• Enabled: Return the barcode check result of each label to the host as
follows:
•When the check is successful: <STX>BV, OK<ETX>
•When the check is unsuccessful: <STX>BV, NG<ETX>
• Disabled: Do not return the barcode check results to the host.
Logs
Tools > Barcode Checker > Settings > Logs
Manage the barcode check logs saved in the printer.
Available only if there are barcode check logs in the printer.
Note that new logs are overwritten on older logs when the log file reaches
its maximum size (1MByte).
The setting items are as follows:
1 Copy
2 Remove
The barcode check log data is created in the following format:
YYYY/MM/DD hh:mm:ss(ZZZ) [TTTTTTT] READING[IR]:SRSR:drdr...<CR><LF>
Format ID
YYYY
MM
DD
hh
mm
ss
ZZZ
TTTTTTT
IR
SRSR
drdr...
Copy the barcode check log file to the USB
memory.
*Available only if you have installed the USB
memory.
Remove the barcode check logs.
[RRRRRRR] COMMAND[IC]:SCSC:dcdc...<CR><LF>
The date when the barcode check was performed.
YYYY: year
MM: month
DD: day
hh: hour
mm: minute
ss: second
ZZZ: time zone
* If the optional RTC kit is not installed, the system time will be output.
The total number of printed labels after the printer is powered on.
*When the total number of printed labels becomes greater than an 8-digit
number, the output digit will increase.
The number of read data received after reaching the position at which the check
starts.
*When the check result is "IGNORED", this shows "00".
Size of read data (bytes)
Read data
4 Operation and Configuration
Description
CL4NX/CL6NX Operator Manual
235