SATO CL4NX Operator's Manual page 120

4 Operation and Configuration
IPv6
Interface > Network > Settings > Wi-Fi > IPv6
Configure IPv6 for Wi-Fi. The setting items are as follows:
1 Mode
2 DHCP / Renew
Lease
3 IP Address
4 Prefix Length
5 Gateway
6 DNS
CAUTION
After doing the settings, return to the Wi-Fi screen by pressing the
back button, and then press the right soft button to enable the new
settings. Press the left soft button to cancel the new settings and return to
the previous settings.
Note
When Wi-Fi Direct is active, this IPv6 screen is not shown. In addition, you
cannot change IP Address, Prefix Length, Gateway or DNS if Mode is
anything other than Static.
118
CL4NX/CL6NX Operator Manual
Select the IP address assignment method or
disable IPv6.
Update the lease time and get the IP address
from the DHCP server again.
*Shows only if you have selected DHCP in the
Mode menu.
*Does not show if LAN is the active interface.
Set and check the IP address.
If you have selected DHCP in the Mode menu,
the screen shows the IP address you received
from the DHCP server.
If you have selected Static in the Mode menu,
select to set the IP address.
Set and check the prefix.
Set and check the default gateway address.
If you have selected DHCP in the Mode menu,
the screen shows the gateway address you
received from the DHCP server.
If you have selected Static in the Mode menu,
select to set the default gateway address.
Set and check the address of the primary DNS
server.
If you have selected Static in the Mode menu,
select to set the primary address of the DNS
server.