More Information About Command Error - SATO CL4NX Operator's Manual

6.1.1

More Information about Command Error

Printer motion when detecting a command error
When Show Error is set to ENABLE in Applications >
SBPL, the command error information is shown on
the error message (second line), and the print
operation is paused.
This error can be cleared by pressing the left soft
button CANCEL X, but the data in which an error is
detected is discarded and cannot be printed.
Location of error occurrence
"Caaa" in the command error message shows the
location of command error.
The number of ESC commands from ESC+A is
shown in "aaa".
Note that the ESC+A command is not included in the number of ESC commands, which can be shown
up to 999. If the number of ESC commands exceeds 999, it is shown as "999".
Example)
When a command error is detected by the Horizontal Print Position <H> command.
-------: [ESC]A
C001: [ESC]V100
C002: [ESC]H99999
C003: [ESC]L0202
C004: [ESC]M,ABCDEF
C005: [ESC]Q1
C006: [ESC]Z
In this case, C002 is the location of the error.
Error command name
The command name, in which an error is detected, is shown in "<bb>".
* A one-byte command name is left aligned.
Error description
The cause of command error will be shown in "cc" in the error message ("Caaa:<bb>:cc").
Description ("cc")
Invalid command
Invalid parameter
Command table read error
Invalid graphic data/
custom designed data
Invalid registration area
This number is already
registered
Over registration area limit
=> Location of the command error
Analyzed improper command.
Received improper parameter.
Failed to read the command table.
Analyzed improper graphic and custom designed data.
Specified memory area (card slot) is inappropriate.
Tried to write to a write-protected media.
Number specified by registration command has already been
taken.
Exceeded the registration area. (Memory full).
Command error information
Cause
CL4NX/CL6NX Operator Manual
6 Troubleshooting
283