SATO CL4NX Operator's Manual page 149

Traps
Interface > Network > Services > SNMP > Traps
Set the Traps function.
The setting items are as follows:
1 Enable
2 SNMP Version
3 IP Version
4 Destinations
5 Destination 1
6 Destination 2
7 Destination 3
8 Community
9 User
10 Engine ID
11 Security
12 Authentication
Protocol
13 Authentication
Passphrase
14 Privacy Protocol
15 Privacy
Passphrase
Use the Traps function.
Set the SNMP version.
Set the IP version.
Set the number of trap destinations.
Set address 1 for the trap destination.
Set address 2 for the trap destination.
*Shows only if you have selected 2 or 3 in the
Destinations menu.
Set address 3 for the trap destination.
*Shows only if you have selected 3 in the
Destinations menu.
Set the Traps community name.
*Shows only if you have selected 1 or 2c in the
SNMP Version menu.
Set the Traps user name.
*Shows only if you have selected 3 in the
SNMP Version menu.
Set the engine ID.
*Shows only if you have selected 3 in the
SNMP Version menu.
Set the security level.
*Shows only if you have selected 3 in the
SNMP Version menu.
Set the authentication protocol.
*Shows only if you have selected
Authentication or Privacy in the Security
menu.
Set the authentication passphrase.
*Shows only if you have selected
Authentication or Privacy in the Security
menu.
Set the privacy protocol.
*Shows only if you have selected Privacy in
the Security menu.
Set the privacy passphrase.
*Shows only if you have selected Privacy in
the Security menu.
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
147