SATO CL4NX Operator's Manual page 167

Outputs
Interface > External I/O > Signals > Outputs
Set the output pin No. of the signals.
/
Press the buttons to highlight the item that you want to change,
/
then press the buttons to change the pin No.
Press the button to save the settings and return to the Signals menu.
The setting items are as follows:
1 Paper End/
Paper/Ribbon End (If
RFID Mode is enabled)
(CL4NX only)
2 Ribbon End/
RFID Tag Error (If
RFID Mode is enabled)
(CL4NX only)
3 Machine Error/
Machine/RFID Error (If
RFID Mode is enabled)
(CL4NX only)
4 Print Done
5 Qty/Offline
6 Ribbon Near End
7 Dispenser
8 Label Near End
The options for each signal output are as follows:
• PIN 1: Set the selected signal to pin 1.
• PIN 3: Set the selected signal to pin 3.
• PIN 4: Set the selected signal to pin 4.
• PIN 6: Set the selected signal to pin 6.
• PIN 9: Set the selected signal to pin 9.
• PIN 10: Set the selected signal to pin 10.
• OFF: Set the selected signal to off mode.
Note
You cannot set any outputs using the same pin number. If you attempt to set the
same number, the settings will show in red and you cannot save the settings.
Set the output pin No. of the Signal Paper End.
Set the output pin No. of the Signal Paper/
Ribbon End if you have installed the RFID.
Set the output pin No. of the Signal Ribbon End.
Set the output pin No. of the Signal RFID Tag
Error if you have installed the RFID.
Set the output pin No. of the Signal Machine Error.
Set the output pin No. of the Signal Machine/
RFID Error if you have installed the RFID.
Set the output pin No. of the Signal Print End.
• MODE1: The output signal becomes
"Active" when there is remaining print data
without error in online mode.
• MODE2: The output signal becomes
"Active" when the printer is Online.
Set the output pin No. of the Signal Ribbon Near End.
Set the output pin No. of the Signal Dispenser.
*To use this signal, connect the dispenser unit
or linerless cutter kit (CL4NX only).
Set the output pin No. of the Signal Label Near End.
*This feature is supported on printers from
serial number 6B~ and above.
4 Operation and Configuration
(If RFID Mode is enabled)
(CL4NX only)
CL4NX/CL6NX Operator Manual
165