Adjusting The Print Speed - SATO CL4NX Operator's Manual

5
Press the / buttons to select a value.
The setting range is from 1 to 10. 1 is the lightest
and 10 is the darkest.
6
Press the right soft button or
save the value.
7
Press the button to change to offline mode.
8
Press the button again to change to online mode.
You can perform printing to check the print quality.
5.4.2

Adjusting the Print Speed

The adjustment of the print speed not only changes the speed of printing but also affects the print quality.
The setting range of the print speed varies depending on the following print resolution:
<CL4NX>
• Resolution 8 dots/mm): 2 to 10 (inches/sec)
203 dpi (
• Resolution 12 dots/mm): 2 to 8 (inches/sec)
305 dpi (
• Resolution 24 dots/mm): 2 to 6 (inches/sec)
609 dpi (
<CL6NX>
• Resolution 203 dpi (8 dots/mm): 2 to 10 (inches/sec)
• Resolution 305 dpi (12 dots/mm): 2 to 8 (inches/sec)
Note
• When Prioritize in the Printing > Advanced menu has been set to Commands, the data will be printed
with the print speed specified by command.
• To adjust the print speed while pausing the print job, refer to
During Printing.
Note (CL4NX only)
If the optional linerless cutter kit is installed, the setting range will be from 2 to 6 ips (inches/sec) regardless of
the print resolution of the printer.
The adjustment procedure for the print speed is as follows:
1
When the printer is in online mode, press
the button to change the printer to
offline mode.
5 Cleaning and Performing Printer Adjustments
button to
Section 4.1.5 Adjusting the Print Settings
CL4NX/CL6NX Operator Manual
269