SATO CL4NX Operator's Manual page 227

Remove
Tools > HEX-Dump > Log Files > Remove
Delete the log files of the printer.
The procedure to delete the log files is as follows:
1. Select the file type to delete and press the
• buff/: The buffer data saved after you perform the Buffer Dump.
• hexdump/: The received data created through Hex Dump Mode.
2. Select the file to delete and press the
on the right side of the file name.
3. After you select the file, press the right soft button to delete the
selected file.
Note
When Hex Dump Mode is set to Enabled, it may take some time before
the files are shown.
Print
Tools > HEX-Dump > Log Files > Print
Print a hex dump of the log files of the printer.
The procedure to print the log files is as follows:
1. Select the file type to print and press the
• buff/: The buffer data saved after you perform the Buffer Dump.
• hexdump/: The received data created through Hex Dump Mode.
2. Select the file to print and press the
perform the dump print.
CAUTION
Printing the contents of the file may use a lot of media.
Note
When Hex Dump Mode is set to Enabled, it may take some time before
the files are shown.
button.
button. A checkmark shows
button.
button or right soft button to
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
225