SATO CL4NX Operator's Manual page 376

7 Appendix
Supplementary explanation
• Keep the print start signal (PRIN) to "Low" until print end signal (Print done) is outputted. Refer to the
below Maintaining the Print Start Signal (PRIN)
• Keep the output reprint signal (PRIN2) for more than 10 ms. When signal is outputted for shorter than
10 ms, and reprint signal is not acknowledged, the printer does not perform reprinting.
Maintaining the Print Start Signal (PRIN)
Item
TYPE 1, 2
Print Start
(PRIN)
Reprint
(PRIN2)
Print
Print End
(Print Done)
TYPE 3, 4
Print Start
(PRIN)
Reprint
(PRIN2)
Print
Print End
(Print Done)
374
CL4NX/CL6NX Operator Manual
Input Waveform
TYPE 1
TYPE 2
There is no problem to make the PRIN signal to High
during the dotted line with TYPE 3 and 4.
TYPE 3
TYPE 4
timing chart.
Printed 1 piece
Printed 1 piece