SATO CL4NX Operator's Manual page 280

6 Troubleshooting
Error
No.
Cutter cover open
1016
SBPL command error
1017
RFID tag error (CL4NX only)
1018
RFID system error (CL4NX only)
1019
278
CL4NX/CL6NX Operator Manual
Message
The cutter-open lever is open.
To clear the error: The cable of the cutter unit is
Close the bracket disconnected.
of the cutter.
The cutter open sensor is
defective.
Incorrect command or
parameter in the print data.
Caaa: position of error
To clear the error:
occurrence
Press the Cancel
<bb>: error command name
or button.
cc: error code
Could not read/write to the
RFID inlay.
To clear the error:
Press the ABORT
or RETRY button
when they are
available.
The error
message shows
each time the
error occurs, but
the buttons are
not shown until
the number of the
printer's encoding
attempts reaches
the value
specified in RFID
> Retries in the
Interface menu.
RFID module is not operating
correctly.
To clear the error:
Power off the
printer.
Cause
Close and lock the cutter-open
lever.
Connect the cable of the cutter
unit correctly.
Replace the cutter open
sensor.
Check the print data.
Discard this tag.
Contact the technical support
center for repair of the RFID
module.
Countermeasure