SATO CL4NX Operator's Manual page 236

4 Operation and Configuration
VOID Print
Tools > Barcode Checker > Settings > VOID Print
Set whether to print error marks on the media when a barcode reading
error or barcode comparison error occurs.
6 x 6 mm (0.24" x 0.24") error marks are printed within the width of the print
data image and in a length of up to 30 mm (1.18") from the trailing end of
the label. The length varies depending on the image length of the print
data and the operation mode.
6 mm
(0.24")
6 mm
(0.24")
The options are as follows:
• Enabled: If a reading error or comparison error occurs, the printer
prints error marks on the label without pausing.
After VOID printing, the printer prints and checks the same label until it
reaches the number of retries specified in Retries. If the error still
occurs after the specified number of retries are done, the printer pauses
after VOID printing, and shows an error message on the display.
• Disabled: If a reading error or comparison error occurs, the printer
pauses and shows an error message on the display.
Note
Printing of the VOID mark is not supported in dispenser and linerless
(CL4NX only) modes.
Retry Count
Tools > Barcode Checker > Settings > Retry Count
Set how many times the printer will try to print and check the same
barcode after VOID printing when a barcode reading error or barcode
comparison error occurs.
Shows only if you have selected Enabled in the VOID Print menu.
The setting range is from 0 to 10.
As long as the error continues to occur, the label is reprinted up to the
number of times specified in this setting.
For example, if you set it to 0, if the error occurs while checking the first
label, the printer pauses and shows an error message after VOID printing.
If set to 5, if the error continues to occur until the 6th label, the printer
pauses after VOID printing for the 6th label, and shows an error message.
234
CL4NX/CL6NX Operator Manual