SATO CL4NX Operator's Manual page 233

Barcode Checker
Tools > Barcode Checker
Set the barcode check function.
By connecting a barcode checker to the printer, you can verify the
barcodes after printing.
Refer to Section 7.6 Optional Barcode Check Function Configuration
for details on the barcode check function.
The setting items are as follows:
1 Test
2 Settings
Note
• This function cannot be used in the following conditions:
•When the print mode is tear-off mode
•When you are using CL4NX RFID models
•When the printer is in AEP mode
• Use the optional barcode checker stand kit to mount the barcode
checker to the printer. For details, refer to the Barcode Checker Stand
Kit Installation Manual that came with the barcode checker stand kit.
Test
Tools > Barcode Checker > Test
Set up the barcode checker.
Available only if you have connected the barcode checker.
The setting items are as follows:
1 Reader Name
2 Reading Test
Set up the barcode checker.
*Available only if you have connected the
barcode checker.
Set the barcode check function.
Shows the barcode checker connected to the
printer.
Perform a test read with the connected barcode
checker.
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
231