Troubleshooting Table; No Power/Nothing On The Screen; Cannot Feed The Media - SATO CL4NX Operator's Manual

6 Troubleshooting

6.3 Troubleshooting Table

Check the items below when the printer does not operate correctly.
WARNING
• Do not touch the power button, connect or disconnect the power cord while your hands are wet. Doing so
could cause an electric shock.
• Disconnect the power cord from the AC outlet before you perform the cleaning.
Note
You can purchase a cleaning kit or cleaning sheet from a SATO reseller or technical service center.
6.3.1

No Power/Nothing on the Screen

No.
1 Is the power cord fully connected to the AC
outlet?
2 Is the power cord fully connected to the printer?
3 Is the power cord damaged?
4 Is there electricity at the AC outlet that supplies
the power to the printer?
6.3.2

Cannot Feed the Media

No.
1 Are the media and ribbon designed for the
printer?
2 Are the media and ribbon loaded correctly?
3 Is the media or ribbon deformed?
4 Is the media guide set correctly?
5 Is the correct sensor type set?
6 Is the sensitivity of the sensor set correctly?
286
CL4NX/CL6NX Operator Manual
What to check
What to check
Countermeasure
Connect the power cord to the AC outlet fully.
Connect the power cord to the AC input terminal
of the printer fully.
Replace the power cord.
Contact a SATO reseller or technical service
center for the specific power cord for this printer.
Do not use power cords that are not designed
specifically for this printer.
Check if there is electricity at the AC outlet.
Connect to another AC outlet.
Countermeasure
Use media and ribbon designed for the printer.
Load the media and ribbon correctly.
Use the media or ribbon that is not deformed.
You cannot feed the media or ribbon that is
deformed.
Adjust the media guide.
Set the correct sensor type.
Adjust the sensor level.