SATO CL4NX Operator's Manual page 204

4 Operation and Configuration
Vert. Offset
Applications > SEPL > Home Reference > Vert. Offset
Specify the offset position in the vertical direction.
The setting range is from 0 to 400 dots.
Memory Device
Applications > SEPL > Memory Device
Select the printer's memory space in which to store forms, graphics and
fonts.
The options are as follows:
• Internal RAM: Use the printer's RAM. The data will be lost if the printer
is powered off.
• Internal FLASH: Use the printer's flash memory.
• Front USB: Use the USB memory connected to the USB connector
(Type A) on the front side of the printer.
• Rear USB: Use the USB memory connected to the USB connector
(Type A) on the rear side of the printer.
CAUTION
Be sure to perform a virus check for the USB memory before connecting it
to the printer. SATO Corporation shall not be held responsible for any
printer malfunctions caused by a virus spread via USB memory.
Sim. 300 DPI Head
Applications > SEPL > Sim. 300 DPI Head
When you are using the printer with 305 dpi resolution, enable or disable
300 dpi simulation mode.
The options are as follows:
• Enabled: Enable 300 dpi simulation mode. The sizes and positions of
objects such as lines, boxes and barcodes in the print data are
automatically adjusted to the equivalent 300 dpi sizes and positions for
printing.
• Disabled: Disable 300 dpi simulation mode.
202
CL4NX/CL6NX Operator Manual