Connecting The Interface Cable; Available Interfaces - SATO CL4NX Operator's Manual

2 Installing the Printer

2.4 Connecting the Interface Cable

The connection of the interface cable is explained as follows:
2.4.1

Available Interfaces

This printer supports the following interfaces.
A printer connected with multiple interface cables can continue to operate when receiving data.
However, you cannot receive data from more than one interface at a time. Normally, do not use multiple
interfaces at a time.
The printer prints the received data in the reception order. The next received data is stored in the receive
buffer while the first data is printed.
• NFC (front side)
*This feature is supported on printers from serial
number 6B~ and above.
• USB
• LAN
• Bluetooth
• RS-232C
• IEEE1284
• External signal (EXT)
• Wireless LAN
Note
• The wireless LAN interface is optional.
• The NFC interface supports the handover function that simplifies the Bluetooth/Wi-Fi connection setup with
Android devices. For details, refer to
In addition, the NFC interface can be used for changing printer settings with an Android device while the
printer is powered off and the power cord is not connected.
CAUTION
Do not connect or disconnect the interface cables (or use a switch box) with power supplied to either the
printer or computer. This may cause damage to the interface circuitry in the printer or computer and is not
covered by warranty.
26
CL4NX/CL6NX Operator Manual
Section 2.4.3 NFC Interface Connection.