Adjusting The Print Position - SATO CL4NX Operator's Manual

Linerless Mode (CL4NX only)
I-mark Linerless Label
Non-printable
zone (5 mm /
0.2")
5.3.2

Adjusting the Print Position

Set the Pitch in the Printing > Advanced > Adjustments menu to adjust the print position.
Media feed direction
Adjustment for
"+" value
No
adjustment
Adjustment for
"-" value
Note
The above base reference point (print position) will be the stop position when the sensor type is set to Gap
sensor.
5 Cleaning and Performing Printer Adjustments
Cut
position
Print
position
Print position
(Print head)
-3.75 mm (-0.15") ~ +3.75 mm (+0.15")
Gap sensor
Setting range:
<CL4NX>
203 dpi: -30 to +30 dots
305 dpi: -45 to +45 dots
609 dpi: -90 to +90 dots
<CL6NX>
203 dpi: -30 to +30 dots
305 dpi: -45 to +45 dots
CL4NX/CL6NX Operator Manual
263