SATO CL4NX Operator's Manual page 234

4 Operation and Configuration
Reading Test
Tools > Barcode Checker > Test > Reading Test
Perform a test read with the connected barcode checker.
Available only if you have connected the barcode checker.
Set a label with barcodes within the scanning range of the barcode
checker, and then press the right soft button to start reading.
If reading is successful, the code type and read data are displayed. The
data is displayed only up to 23 bytes from the beginning.
If the reading is unsuccessful, or if the displayed read result is not correct,
adjust the position of the barcode checker by operating the barcode
checker stand. For details on how to use the barcode checker stand, refer
to the Barcode Checker Stand Kit Installation Manual that came with the
barcode checker stand kit.
Settings
Tools > Barcode Checker > Settings
Set the barcode check function.
The setting items are as follows:
1 Mode
2 Start Position
3 VOID Print
4 Retry Count
5 Host Notification
6 Logs
232
CL4NX/CL6NX Operator Manual
Select the check mode or disable the barcode
check function.
Adjust the position at which the barcode check
starts (position of the barcode checker at which
reading starts).
Set whether to print error marks on the media
when a barcode reading error or barcode
comparison error occurs.
Set how many times the printer will try to print
and check the same barcode after VOID
printing when a barcode reading error or
barcode comparison error occurs.
*Shows only if you have selected Enabled in
the VOID Print menu.
Set whether to return the barcode check results
to the host from which the print data is sent.
Manage the barcode check log file saved in the
printer.