Paper End - SATO CL4NX Operator's Manual

4 Operation and Configuration
Finisher Feed
Printing > Advanced > Finisher Feed
Set the media feed amount for Tear-off, cut and dispense stop.
Set the media feed amount based on the print head position of 0.
The actual media feed amount is the value of Offset + Finisher Feed.
The setting range varies depending on the print resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: 0 to 2040 dots
• 305 dpi: 0 to 3060 dots
• 609 dpi: 0 to 6120 dots
<CL6NX>
• 203 dpi: 0 to 2040 dots
• 305 dpi: 0 to 3060 dots

Paper End

Printing > Advanced > Paper End
Select the sensor for sensing the paper end.
The options are as follows:
• Using I-mark: Use the I-mark sensor (reflective type) to sense the
paper end.
• Using Gap: Use the Gap sensor (transmissive type) to sense the paper
end.
Head Base Position
Printing > Advanced > Head Base Position
Set the position used for the base reference point for printing.
The options are as follows:
<CL4NX>
• Standard: Print with a standard base reference point.
• Left-justify: Move the base reference point 2 mm (0.08") to the left
(when you face the printer).
<CL6NX>
• Standard: Print with a standard base reference point.
• Left-justify: Move the base reference point 2 mm (0.08") to the left
(when you face the printer). Expand the width of the printable area.
Refer to Printable Area
Note
The message prompting to restart the printer will appear on the online/
offline screen if you have made any changes. In such a case, reboot the
printer to make the setting effective.
102
CL4NX/CL6NX Operator Manual
in Section 7.7.1 Hardware for details.