SATO CL4NX Operator's Manual page 326

7 Appendix
10
Adjust the position of the RFID antenna. Rotate the dial e to align the pointer r with
the media being used.
When the Antenna Pitch is set to Standard in the Interface > RFID menu, adjust the physical position of
the antenna according to the settings required for the specific media and inlay used. Refer to the
"Antenna Position" of the Inlay Placement & Configuration Table in the CL4NX Inlay Configuration
Guide*.
* To see the CL4NX Inlay Configuration Guide, access the following URL:
http://www.satoworldwide.com/rfid/
Blue Yellow Green
11
Load the media and ribbon.
Refer to Section 3.2 Loading the Ribbon
12
Confirm the operation by printing/encoding a media.
Make sure that you read the data and check that it is correctly encoded.
324
CL4NX/CL6NX Operator Manual
4
and Section 3.5 Loading Media
3
for details.