Static Routes; Table 12: Ucm6100 Network Settings-­>802.1X; Figure 26: Ucm6100 Using 802.1X Eap-­Md5 - Grandstream Networks UCM6100 Series User Manual

The following table shows the configuration parameters for 802.1X on UCM6100. Identity and MD5
password are required for authentication, which should be provided by the network administrator obtained
from the RADIUS server. If "EAP-­TLS" or "EAP-­PEAPv0/MSCHAPv2" is used as the 802.1X mode, users
will also need upload 802.1X CA Certificate and 802.1X Client Certificate, which should be also generated
from the RADIUS server.
802.1X Mode
Identity
MD5 Password
802.1X Certificate
802.1X Client
Certificate
STATIC R OUTES
The UCM6100 provides users static routing capability that allows the device to use manually configured
routes, rather than information only from dynamic routing or gateway configured in the UCM6100 web
GUI-­>Network Settings-­>Basic Settings to forward traffic. It can be used to define a route when no other
routes are available or necessary, or used in complementary with existing routing on the UCM6100 as a
failover backup, and etc.
Firmware Version 1.0.9.26
Figure 26: UCM6100 Using 802.1X EAP-­MD5
Table 12: UCM6100 Network Settings-­>802.1X
Select 802.1X mode. The default setting is "Disable". The supported 802.1X
mode are:
EAP-­MD5
•
EAP-­TLS
•
EAP-­PEAPv0/MSCHAPv2
•
Enter 802.1X mode identity information.
Enter 802.1X mode MD5 password information.
Select 802.1X certificate from local PC and then upload.
Select 802.1X client certificate from local PC and then upload.
UCM6100 Series IP PBX User Manual Page 60 of 304