Figure 135: Create New Event List - Grandstream Networks UCM6100 Series User Manual
Ip pbx
Hide thumbs
Also See for UCM6100 Series:
- User manual (418 pages) ,
- Manual manual (24 pages) ,
- Configuration (19 pages)
Table of Contents
Advertisement
Special Extensions
Remote extension monitoring works on the UCM6100 via event list BLF, among Peer SIP trunks or
Register SIP trunks (register to each other). Therefore, please properly configure SIP trunks on the
UCM6100 first before using remote BLF feature. Please note the SIP end points need support event list
BLF in order to monitor remote extensions.
When an event list is created on the UCM6100 and remote extensions are added to the list, the UCM6100
will send out SIP SUBSCIRBE to the remote UCM6100 to obtain the remote extension status. When the
SIP end points registers and subscribes to the local UCM6100 event list, it can obtain the remote
extension status from this event list. Once successfully configured, the event list page will show the status
of total extension and subscribers for each event list. Users can also select the event URI to check the
monitored extension's status and the subscribers' details.
--------------------------------------------------------------------------------------------------------------------------------------------
Firmware Version 1.0.9.26
manually enter the remote extensions under "Special Extensions" field.
Manually enter the remote extensions in the peer/register trunk to be
monitored in the event list.
Valid format: 5000,5001,9000
Figure 135: Create New Event List
UCM6100 Series IP PBX User Manual
Page 231 of 304
Advertisement
Table of Contents
Troubleshooting
