INTERNAL
O PTIONS/JITTER
B UFFER
SIP Jitter Buffer
Enable Jitter Buffer
Jitter Buffer Size
Max Jitter Buffer
Implementation
INTERNAL
O PTIONS/RTP
S ETTINGS
RTP Start
RTP End
Firmware Version 1.0.9.26
extensions can be assigned on the UCM6100 to provision the end
device.
Conference Extensions: 6300-6399
•
Ring Group Extensions: 6400-6499
•
Queue Extensions: 6500-6599
•
Voicemail Group Extensions: 6600-6699
•
IVR Extensions: 7000-7100
•
Fax Extensions: 7200-8200
•
Table 77: Internal Options/Jitter Buffer
Select to enable jitter buffer on the sending side of the SIP channel. The
default setting is "No".
Configure the time (in ms) to buffer. This is the jitter buffer size used in
"Fixed" jitter buffer, or used as the initial time for "adaptive" jitter buffer.
The default setting is 100.
Configure the maximum time (in ms) to buffer for "Adaptive" jitter buffer
implementation, or used as the jitter buffer size for "Fixed" jitter buffer
implementation. The default setting is 200.
Configure the jitter buffer implementation on the sending side of a SIP
channel. The default setting is "Fixed".
Fixed
•
The size is always equal to the value of "Max Jitter Buffer".
Adaptive
•
The size is adjusted automatically and the maximum value equals to
the value of "Max Jitter Buffer".
Table 78: Internal Options/RTP Settings
Configure the RTP port starting number. The default setting is 10000.
Configure the RTP port ending address. The default setting is 20000.
UCM6100 Series IP PBX User Manual
Page 252 of 304